Buy Used DL3000 2P by Camco

Contact a Sales Specialist about used DL3000 2P for sale.

DL3000 2P Amp Rack Units

Camco Poweramp DL 3000 2P

Fortune:
8 ohms stereo 790 watts
4 Ohm Stereo 1250 Watts
2 ohm stereo 1650 watt
8 Ohm mono 2500 Watts
4 ohms mono 3300 watts

Peak fortune:

8 ohms stereo 1110 watts
2110 watt 4 ohm stereo
2 ohm stereo 2880 watt
8 ohms mono 4220 watts
4 Ohm mono 5760

Signaal Ruis verhouding:
105 dB

Frequenti bereik:

5 Hz - 60,000 Hz + _ 3 dB

230 Volt ac

Weight: 31 kg

Camco Amp Rack Units

CAMCO is a manufacturer of high-end pro audio amplifiers, DSP- and audio network solutions, which have gained a worldwide reputation for transparent sonic performance, extreme power and ultra reliability

Hertz - A unit of measure for frequency generally applied to waveforms, one Hertz is equal to one cycle in one second. It is abbreviated Hz so that 100 Hz would be 100 cycles per second. However, the unit m. Used . ay be applied to periodic events other than waveforms like the second hand on a clock, which would cycle at 1 Hz, or a human heart that may beat at 1.2 Hz. Named after the German physicist H. Used . einrich Rudolf Hertz, the name was established in 1930, but did not replace the term cycles per second until the 1970s.

...

Motors - Motors are any electrical or mechanical device used to power lifts that aid the ground support crew in placing gear up onto stages or trusses.. Used . . Used . ...

Address - In computer science, a memory address is a unique identifier for a memory location at which a CPU or other device can store a piece of data for later retrieval. In modern byte-addressable computers, e. Used . ach address identifies a single byte of storage; data too large to be stored in a single byte may reside in multiple bytes occupying a sequence of consecutive addresses. Some microprocessors . Used . were designed to be word-addressable, so that the typical storage unit was actually larger than a byte. Examples include the Texas Instruments TMS9900 and the National Semiconductor IMP-16, both of which used ...

Cabinets - A cabinet is a loudspeaker enclosure designed to prevent sound waves from the rear of the speaker combining with the sound waves from the front of the speaker creating
interference that would c. Used . ause the efficiency of the speaker to be compromised.. Used . ...

Subs - A sub or subwoofer is a speaker dedicated to the reproduction of bass frequencies, usually from about 20 Hz to about 200 Hz. . Used . . Used . ...

Amp Rack Units

Amp rack units refer to an assortment of rack-mounted or rack-protected PA amplification or sound reinforcement equipment that is set up to work with a mixer and loudspeakers. An amplifier, also called a power amplifier, is a basic signal processing unit that increases the power of an audio signal to make the sound from a human voice or music louder. A pro audio amplifier is used in professional sound systems as the last active component in the signal chain because it receives input from mixers or other signal processing units, increases the power of the signal, and sends the output to speakers. There are other types of amplifiers also referred to as amp rack units. A touring amplifier is simply a power amplifier that is designed to withstand conditions that touring musicians are exposed to especially being on the road most of the time. Live power amplifiers are used to support the audio demands of live performances. These amps make help create the unique experience of sound in live concerts. Some amp rack units are built by combining or adding amplifier modules with other parts. These are amplifier sub-units or parts designed to meet certain specifications. To have a whole amplification unit you may need a transformer, bridge rectifiers and filter capacitors, speaker connectors, input connectors, volume control, heatsink and a suitable rack mount case.